Creating Smooth Styles
Step
1
Ensure the hair is clean, dry and free of dry shampoo, hairspray, mousse, spray wax, styling dust and all other styling products.
Step
2
Comb through to remove any tangles and divide the hair into sections, no bigger than 3cm wide.
Step
3
To turn the appliance on, slide the switch to the heat setting suitable for your hair type (See Heat Settings).
Step
4
Select the smooth setting by sliding the switch to straight mode (See Wave or Smooth Settings).
Step
5
Always insert the hair into the appliance with the plate part facing towards the head. Place a section of hair between the straightening plates, close to the roots.
IMPORTANT! The neat section of hair must be inserted into the opening, beyond the hair stopper (A) until it reaches the hair guide (B). If too much hair is placed into the appliance opening and outside of hair stopper (A) the appliance will beep continuously.
To continue using, remove the appliance from the hair and insert smaller sections of hair.
Step
6
Firmly close the handles together to allow the hair to be drawn into the ceramic chamber.
IMPORTANT! Once the hair has begun to be drawn into the ceramic chamber hold the hair firmly between the straightening plates and immediately slide down the length of the hair from root to tip.
IMPORTANT! If the appliance is not released from the hair it will beep continuously and the power indicator will flash until the handles are released. To continue using the appliance, remove from the hair and use as normal.
Step
7
To allow the style to set, do not comb or brush the hair until it cools.
Step
8
After use, switch off and unplug the appliance.
Heat Settings
If you have delicate, fine or coloured hair, use the lower heat settings. For thicker hair, use the higher heat settings.
It is suggested to always complete a test on initial use to ensure the correct temperature is used on the hair type. Start on the lowest setting and increase the temperature until desired result is achieved. See guide of the temperature settings.
Wave or Smooth Settings
The wave or smooth setting allows you to switch between the Wave Mode for perfectly formed waves or Smooth Mode for a sleek finish without flattening.
Wave Direction Settings
The wave direction settings allow you to choose the direction of your wave formation.